Parts Of Induction Start Induction Run Motor



























































Comments

Post a Comment

Popular posts from this blog

Automatic Load Sensing Power Switch Circuit Diagram

Image
This circuit will automatically switch on several mains-powered "slave" loads when a "master" load is turned on. For example, it will switch on the amplifier and CD player in a stereo system when the receiver is turned on. It works by sensing the current draw of the "master" device through a low value high wattage resistor using a comparator. The output of that comparator then switches on the "slave" relay. The circuit can be built into a power bar, extension cord or power center to provide a convenient set of "smart" outlets that switch on when the master appliance is powered (turn on the computer monitor and the computer, printer and other peripherals come on as well). Automatic Load Sensing Power Switch Circuit Diagram     Parts Part               Total Qty. Description C1, C3               2            ...
Keep reading

Build Your Own RC Tankbot

Image
Here’s a blog post that will show you the setup you’ll need to make your own do-it-yourself radio controlled (RC) tankbot from the ground up. This example uses a few kits from Solarbotics to build your own RC controller, communication link, and tankbot using minimal parts. We even managed to get 250 feet of range out of the deal! For this exploit we invite you to move over to the dark side, as the heart of the project isn’t Xbees but instead 2.4GHz IEEE 802.15.4 Radio Frequency Network modules from Synapse Wireless which are actually super simple to use and configure. This post will merely get you started with building a general RC platform, feel free to modify/hack the system to suite your own diabolical requirements.
Keep reading